UPS management software for your DC UPS system

With our management software solutions we enable you to monitor and parameterize your DC UPS system. No matter whether remotely via remote access, in connection with a J. Schneider gateway, or directly on site via the USB/RS485 interface. Easy parameterization allows you to adapt our devices to your requirements.

With the shutdown function, a safe and targeted shutdown of the system is simple and easy.

Further features like the IPC function or the display of the average temperature as well as the used battery life complete the comfort of the software.

The TECControl software offers monitoring and parameterization in one software. Through different user levels it is possible to enable defined rights.

The TECControl service is an alternative to the TECControl software if no monitoring and parameterization is required.

The service runs in the background of the operating system and is only used to shut down the devices, but not for parameterization or monitoring.

Parameterize the "IPC function" according to your needs for an automatic restart.

In the event of a power failure, the connected IPC shuts down in a controlled manner according to the set time. If the mains returns during the shutdown, the IPC does not notice the mains return.

For this reason, the UPS system switches off the output voltage for e.g. 5 seconds (time can be set) and then switches it on again. In this way, the IPC recognizes the return of the mains and automatically starts up again.

Our UCC-TEC is a charger specially designed for charging ultracapacitor modules. At the same time it is also able to charge batteries. With the special paraTEC UCC software you can switch between the two charging modes and parameterize the device

The TECBus Manager is used for monitoring and parameterization of a UPS or an entire master-slave or redundant system with several UPS systems. The software requires the Gateway in combination.